Removing the CPU
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a) side cover
b) air shroud
c) processor heat sink module
3. To remove the central processing unit (CPU):
a) Hold the processor heat sink module upside down.
b) Pry the two processor carrier latchs [1] from the processor heat sink module.
c) Press the other two carrier latchs [2] of the processor carrier and remove it from the slot in the heat sink.
d) Use a torx screwdriver to pry the CPU off the processor heat sink module. Place the blade between the clip and the CPU.
NOTE:
A flatbed screwdriver or plastic scribe can also be used as well.
e) Unlatch the CPU from the two keying latches on the processor carrier and gently lift the CPU.
NOTE:
Avoid touching the CPU contacts with your fingers.
76 Removing and installing components
To Next Page
Loading...
