Component Screw Type Quantity
Up-Bottom air shroud M3X5.0mm 3
Down-Bottom air shroud M3X5.0mm 2
Motherboard #6-32X1/4 inches 12
Front Fan Bracket-MB tray #6-32X1/4 inches 2
Front Fan Bracket-Front wall #6-32X1/4 inches 2
Intruder holder #6-32X1/4 inches 1
Rear Fan bracket #6-32X1/4 inches 2
Rear HDD cover #6-32 UNC X7.0mm 2
Flex0 HDD bay bracket #6-32 UNC X5.45mm 4
Flex0 6025fan bracket for cable attached #6-32 UNC X5.45mm 2
Flex0 6025fan bracket for hot plug #6-32 UNC X5.45mm 2
Flex0 and Flex1 HH ODD bracket #6-32 UNC X5.45mm 4
Flex1 HDD bay bracket #6-32 UNC X5.45mm 4
Flex1 6025fan bracket for cable attached #6-32 UNC X5.45mm 2
Flex1 6025fan bracket for hot plug #6-32 UNC X5.45mm 2
Flex2 HDD bay bracket #6-32 UNC X5.45mm 4
Flex2 6025fan bracket for cable attached #6-32 UNC X5.45mm 2
Flex3 HDD bracket #6-32 UNC X5.45mm 4
Flex3 6025fan bracket for cable attached #6-32 UNC X5.45mm 2
Flex4 HDD bracket #6-32 UNC X5.45mm 4
Flex4 6025fan bracket for cable attached #6-32 UNC X5.45mm 2
HH ODD holder M3X5.0mm 4
HSBP board #6-32 UNC X5.45mm 3
CPU0 cooler/CPU0 Liquid Cooler T-30 torx bolt 4
CPU1 cooler/CPU1 Liquid Cooler T-30 torx bolt 4
Liquid Cooler Bracket #6-32 UNC X5.45mm 12
Recommended tools
The procedures in this document require the following tools:
• Phillips #0 screwdriver
• Phillips #1 screwdriver
• Philips #2 screwdriver
• Plastic scribe
• T-30 torx screwdriver
NOTE:
The #0 screw driver is for screws 0-1 and the #1 screw driver is for screws 2-4.
Removing and installing components 17
To Next Page
Loading...
