PCIe holder
Removing PCIe card holder
1. Follow the procedure in Before working inside your computer.
2. Remove the following:
a) side cover
b) air shroud
3. To remove the PCIe card holder:
NOTE: If full length cards are installed, you will need to remove these cards before removing the holder.
NOTE: If MegaRAID 9460 is installed, disconnect the Super CAP from the card before removing the PCIe card holder
from the system.
a) Disconnect the power cables on either side of the card holder by pressing the tab and pulling it out of the cable slot in the PCIe
holder [1] and [2].
b) Release the dual cables passing through the clip on the card holder [3].
4. Release the latches connecting the front system fan assembly, and lift the PCIe card holder away from the chassis.
24
Removing and installing components
To Next Page
Loading...
