Installing the front HDD cable and fan assembly
1. Connect the fan cables to the connectors on the power distribution and fan control board.
2. Connect the power cable to the connector on the power distribution and fan control board.
3. Connect the SATA 0 cable to the connector on the system board.
4. Replace the front HDD cable and fan assembly into their slots on the chassis and secure them with screws to the chassis.
5. Install the right side cover
6. Follow the procedure in After working inside your computer
Fan and sensor cable assembly
Precision 7920 Tower may have as many as 12 system fans connected to the system board. It is important for technicians to connect
these fans to it's assigned connectors on the system board.
64
Removing and installing components
To Next Page
Loading...
