3. Replac the two side screws and the central screw.
4. To install the SSD carrier slide the carrier in the NVMe flexbay until it clicks in place.
5. Slide the carrier into the drive bay until it clicks into place.
CAUTION:
Ensure that the latch is open before installing the carrier.
6. Lock the latch.
7. Install the following components:
a) HDD bezel
b) side cover
8. Follow the procedure in After working inside your computer.
Front input and output bezel
Removing the front input and output bezel
1. Follow the procedure in Before working inside the computer.
2. Remove the:
a) side cover
b) front bezel
c) HDD and ODD bezel
3. To remove the front Input/Output (I/O) bezel, pry the edges of the panel [1].
Removing and installing components
43
To Next Page
Loading...
