Base Assembly: Dell Precision M6400 Service Manual
file:///T|/htdocs/systems/wsm6400/en/sm/base.htm[11/16/2012 10:26:22 AM]
Back to Contents Page
Base Assembly
Dell Precision™ M6400 Service Manual
Removing the Base Assembly Cover
Replacing the Base Assembly Cover
Removing the Base Assembly
Replacing the Base Assembly
CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage on
www.dell.com at: www.dell.com/regulatory_compliance.
Removing the Base Assembly Cover
1. Follow the procedures in Before Working on Your Computer.
2. Close the display and turn the computer upside down.
3. Remove the two M2 x 3-mm screws.
4. Slide the cover toward the front of the computer to release the tabs from the base assembly.
5. Remove the cover from the base assembly.
1 M2 x 3-mm screws (2) 2 cover
3 bottom tabs (10) 4 front of the computer
Replacing the Base Assembly Cover
1. Align the tabs with the slots on the base assembly.
2. Slide the cover toward the back of the computer to engage the tabs and firmly attach the cover to the base assembly.
To Next Page
Loading...
