Dell Precision M6400 - Page 51

LED and CCFL Displays: Dell Precision M6400 Service Manual
file:///T|/htdocs/systems/wsm6400/en/sm/displayb.htm[11/16/2012 10:27:02 AM]
5. Follow the procedures in After Working on Your Computer.
Removing the Microphone/Camera Board
CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage on
www.dell.com at: www.dell.com/regulatory_compliance.
NOTE: Camera is optional and may not be included on your computer.
1. Follow the instructions in Before Working on Your Computer
.
2. Remove the display bezel (see Removing the Display Bezel
).
3. Disconnect the cable from the microphone/camera board.
4. Remove the two M2.5 x 5-mm screws, and remove the microphone/camera board.
1 display cover 2 microphone/camera board
3 cable connector 4 cable
5 M2.5 x 5-mm screws (2)
Replacing the Microphone/Camera Board
CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage on
www.dell.com at: www.dell.com/regulatory_compliance.
1. Lift the cable out of the way and place the microphone/camera board in the display cover.
2. Connect the cable to the microphone/camera board.
3. Replace the two M2.5 x 5-mm screws.
4. Replace the display bezel (see Replacing the Display Bezel).