Dell S500 - Adjusting the Projected Image; Raising the Projector Height; Lowering the Projector Height

30 Using Your Projector
3 To power off the projector quickly, press the Power button and hold for 1 second
while the projector’s cooling fans are still running.
NOTE: Before you turn on the projector again, wait for 60 seconds to allow the
internal temperature to stabilize.
4 Disconnect the power cord from the electrical outlet and the projector.
Adjusting the Projected Image
Raising the Projector Height
1 Raise the projector to the desired display angle, and use the two tilt adjustment
wheels to fine-tune the display angle.
Lowering the Projector Height
1 Lower the projector, and use the two tilt adjustment wheels to fine-tune the
display angle.
1 Tilt adjustment wheel
(Angle of tilt: -3 to 0.6 degree)
http://www.pureglare.com.au