Dell S500 - Enable Wireless on the Projector

74 Using Your Projector
Enable Wireless on the Projector
In order to use your projector wirelessly, you need to complete the steps below:
1
Install the optional wireless dongle (Optional in S500). See "Installing the
Optional Wireless Dongle" on page 13.
NOTE: Wireless dongle embedded for S500wi.
2
Connect the power cable to the wall outlet and press the power button.
3 Press the Menu button on your projector control panel or remote control.
NOTE: Use , , and buttons to navigate and to select.
4
The wireless connection default is enable. See "Wireless/LAN Settings (in
Wireless Mode)" on page 64.
5 Access the INPUT SOURCE menu, select Multuple Display and then select
Wireless Display on the sub-menu. See "INPUT SOURCE MULTIPLE
DISPLAY" on page 52.
http://www.pureglare.com.au