Dell Studio Hybrid - Replacing the Bottom Logo Assembly; Removing the Bottom Logo Assembly; Removing the Bottom Logo LED

Back to Contents Page
 Replacing the Bottom Logo Assembly
Dell™StudioHybridServiceManual
Removing the Bottom Logo Assembly
Removing the Bottom Logo LED
Installing the Bottom Logo LED
Installing the Bottom Logo Assembly

Removing the Bottom Logo Assembly

1. Follow the procedures in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Remove the drive cage (see Removing the Drive Cage).

4. Remove the processor heat sink (see Removing the Heat Sink).

5. Remove the front I/O panel (see Removing the Front I/O Panel).

6. Remove the back panel (see Removing the Back Panel).

7. Remove the system board (see Removing the System Board).

8. Remove the screw that secures the logo bracket to the chassis.

9. Slide and lift the logo bracket away from the chassis.
Removing the Bottom Logo LED

1. Pry the LED away from the chassis using a screwdriver.

2. Lift the LED away from the chassis.
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.