Dell Studio Hybrid - Installing the Bottom Logo LED; Installing the Bottom Logo Assembly


3. Disconnect the cable attached to the LED.
Installing the Bottom Logo LED

1. Paste the LED between the clamps.

2. Reconnect the cable to the LED.
Installing the Bottom Logo Assembly

1. Align the slots on the logo bracket with the tabs on the chassis. Slide the logo bracket until it clicks into position.

2. Replace the screw that secures the logo bracket to the chassis.

3. Replace the system board (see Installing the System Board).

4. Replace the front I/O panel (see Installing the Front I/O Panel).

5. Replace the back panel (see Installing the Back Panel).

6. Replace the processor heat sink (see Installing the Heat Sink).

7. Replace the drive cage (see Installing the Drive Cage).

8. Replace the computer cover (see Installing the Computer Cover).
Back to Contents Page

NOTE: Ensure that the logo assembly cable does not get entangled during this procedure.