About this task
NOTE: Vostro 15 7510 also supports 6-cell (86 Wh) battery.
NOTE: Inspiron 15 7510 also supports 6-cell (86 Wh) battery.
The following image indicates the location of the 3-cell (56 Wh) battery and provides a visual representation of the installation
procedure.
Steps
1. Using the alignment posts, place the 3-cell battery on the palm-rest and keyboard assembly.
2. Align the screw holes on the 3-cell battery with the screw holes on the palm-rest and keyboard assembly.
3. Replace the five (M2x3) screws that secure the 3-cell battery to the palm-rest and keyboard assembly.
4. Connect the battery cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working on your computer.
Battery cable
Removing the battery cable
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
NOTE:
If battery is disconnected from system board for service, then there is a delay during system boot as the system
undergoes RTC battery reset.
Removing and installing components 21
To Next Page
Loading...
