Steps
1. Using the alignment posts, place the power-button with optional fingerprint reader into its slot on the palm-rest and
keyboard assembly.
2. Replace the screw (M2x4) that secures the power-button with optional fingerprint reader to the palm-rest and keyboard
assembly.
Next steps
1. Install the power-button board.
2. Install the heat sink.
3. Install the GPU fan.
4. Install the base cover.
5. Exit Service Mode.
6. Follow the procedure in After working inside your computer.
Power button with fingerprint reader
Removing the power button with fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
4. Remove the heat sink.
5. Remove the GPU fan.
6. Remove the power-button board.
Removing and installing components
53
To Next Page
Loading...
