Installing the GPU fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the GPU fan and provides a visual representation of the installation procedure.
Steps
1. Lift the Mylar cover to access the cable connector.
2. Route the I/O cable through the routing guides underneath the GPU fan.
3. Slide and place the GPU fan on the palm-rest and keyboard assembly.
4. Align the screw holes on the GPU fan with the screw holes on the palm-rest and keyboard assembly.
5. Replace the two (M2x4) screws to secure the GPU fan to the palm-rest and keyboard assembly.
6. Connect the GPU fan cable to the system board.
Next steps
1. Install the base cover.
2. Exit Service Mode.
3. Follow the procedure in After working inside your computer.
Removing and installing components
35
To Next Page
Loading...
