Steps
1. Disconnect the display cable from its connector on the system board.
2. Remove the two (M2.5x5) screws that secure the left-display hinge to the system board.
3. Remove the two (M2.5x5) screws that secure the right-display hinge to the system board.
4. Open the display hinges at an angle of 90 degrees.
5. Gently slide the palm-rest and keyboard assembly off the display assembly.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
48
Removing and installing components
To Next Page
Loading...
