About this task
The following images indicate the location of the power button with fingerprint reader and provide a visual representation of the
removal procedure.
Steps
1. Disconnect the power button with fingerprint reader cable from the I/O board.
2. Remove the screw (M2x4) that secures the power button with fingerprint reader to the palm-rest and keyboard assembly.
3. Lift the power button with fingerprint reader along with the cable off the palm-rest and keyboard assembly.
Installing the power button with fingerprint reader
About this task
The following images indicate the location of the power button with fingerprint reader and provide a visual representation of the
installation procedure.
54
Removing and installing components
To Next Page
Loading...
