Steps
1. Align and place the power button with fingerprint reader along with the cable on the palm-rest and keyboard assembly.
2. Replace the screw (M2x4) that secures the power button with fingerprint reader to the palm-rest and keyboard assembly.
3. Connect the power button with fingerprint reader cable to the I/O board.
Next steps
1. Install the power-button board.
2. Install the heat sink.
3. Install the GPU fan.
4. Install the base cover.
5. Exit Service Mode.
6. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
4. Remove the heat sink.
Removing and installing components
55
To Next Page
Loading...
