5. Replace the screw (M2x4) that secures the wireless-card bracket to the wireless card and the system board.
Next steps
1. Install the base cover.
2. Exit Service Mode.
3. Follow the procedure in After working inside your computer.
GPU fan
Removing the GPU fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
About this task
The figure indicates the location of the GPU fan and provides a visual representation of the removal procedure.
Steps
1. Flip the Mylar cover open.
2. Disconnect the GPU fan cable from the system board.
3. Remove the two (M2x4) screws that secure the GPU fan to the palm-rest and keyboard assembly.
4. Unroute the I/O cable from routing guides underneath the GPU fan.
5. Slide and lift the GPU fan off the palm-rest and keyboard assembly.
34
Removing and installing components
To Next Page
Loading...
