Steps
1. Using the alignment posts and rubber grommets, place the speakers on the slots of the palm-rest and keyboard assembly.
2. Connect the speaker cable to the system board.
3. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
4. Adhere the tape that secures the speaker cable to the palm-rest and keyboard assembly.
Next steps
1. Install the system board.
2. Install the battery.
3. Install the base cover.
4. Exit Service Mode.
5. Follow the procedure in After working inside your computer.
Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following images indicate the location of the touchpad and provide a visual representation of the removal procedure.
Removing and installing components
43
To Next Page
Loading...
