Dell Vostro 15 7510 - Installing the Memory Module

Steps
1. Lift the Mylar to access the memory module.
2. Pry the retention clips securing the memory module until the memory module pops-up.
3. Remove the memory module from the memory-module slot.
NOTE: Repeat step 1 to step 3 to remove any other memory module installed in your computer.
Installing the memory module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: Vostro 15 7510 supports two memory slots.
NOTE: Inspiron 15 7510 supports two memory slots.
24 Removing and installing components