Steps
1. Slide the display assembly at an angle, and place the display assembly on the palm-rest and keyboard assembly.
2. Using the alignment posts, close the display hinges.
3. Replace the two (M2.5x5) screws that secure the right-display hinge to the system board.
4. Replace the two (M2.5x5) screws that secure the left-display hinge to the system board.
5. Slide the display cable into the connector on the system board.
Next steps
1. Install the heat sink.
2. Install the base cover.
Removing and installing components
49
To Next Page
Loading...
