Steps
1. Using the alignment posts, place the power-button into its slot on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x2) that secure the power-button to the palm-rest and keyboard assembly.
3. Connect the power-button cable to the fingerprint-reader board and close the latch, if applicable.
4. Adhere the tape that secures the power-button cable to the palm-rest and keyboard assembly, if applicable.
Next steps
1. Install the IO board.
2. Install the battery.
3. Install the base cover.
4. Install the SD card.
5. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the wireless card.
About this task
The following images indicate the location of the display assembly and provides a visual representation of the removal
procedure.
44
Disassembly and reassembly
To Next Page
Loading...
