4. Lift and rotate the display panel, then place the display panel on the display assembly.
5. Align the screw holes on the display panel to the screw holes on the display assembly.
6. Replace the six screws (M2.5x2.5) that secure the display panel to the display assembly.
7. Place the display bezel on the display assembly.
8. Align the tabs on the display bezel to the slots on the display assembly.
9. Press down on the display bezel and snap the display bezel in place.
Next steps
1. Install the display bezel.
2. Install the display assembly.
3. Install the wireless card.
4. Install the battery.
5. Install the base cover.
6. Install the SD card.
7. Follow the procedure in After working inside your computer.
Camera
Removing the camera module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Disconnect the battery .
5. Remove the wireless card.
6. Remove the display assembly.
7. Remove the display panel.
8. Remove the display bezel.
About this task
The following images indicate the location of the camera module and provides a visual representation of the removal procedure.
Disassembly and reassembly
55
To Next Page
Loading...
