Dell Vostro 5390 - Installing the M.2 2280 Solid-State Drive

1. Remove the screw (M2x2.5) that secures the solid-state drive to the system board.
2. Slide and remove the solid-state drive from the solid-state drive slot on the system board.
Installing the M.2 2280 solid-state drive
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
1. Align the notch on the solid-state drive with the tab on the solid-state drive slot and slide the solid-state drive into the
solid-state drive slot on the system board.
Removing and installing components
17