Installing the power-button board
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of power-button board and provides a visual representation of the installation
procedure.
1. Align the screw hole on the power-button board with the screw hole on the palm-rest and keyboard assembly.
2. Replace the screw (M1.6x2) that secures the power-button board to the palm-rest and keyboard assembly.
3. Align the screw hole on the power-button bracket with the screw hole on the palm-rest and keyboard assembly.
4. Replace the screw (M1.6x2) that secures the power-button bracket to the palm-rest and keyboard assembly.
1. Install the I/O board.
2. Install the fan.
3. Install the WLAN card.
4. Install the battery.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
Power button with fingerprint reader
Removing the power button with fingerprint reader
NOTE: This procedure is only applicable for computers shipped with a fingerprint reader.
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the WLAN card.
5. Remove the fan.
6. Remove the I/O board.
The following image indicates the location of power button with fingerprint reader and provides a visual representation of the
removal procedure.
30
Removing and installing components
To Next Page
Loading...
