1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Fan
Removing the fan
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
The following image indicates the location of fan and provides a visual representation of the removal procedure.
1. Disconnect the I/O-board cable from the system board and I/O board.
NOTE: This step is only applicable for computers shipped with a WWAN configuration.
2. Remove the two (M2x3) screws that secure the fan to the system board.
3. Lift the fan slightly off the palm-rest and keyboard assembly.
4. Disconnect the fan cable from the system board and completely lift the fan off the palm-rest and keyboard assembly.
20
Removing and installing components
To Next Page
Loading...
