Installing the speakers
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of speakers and provides a visual representation of the installation procedure.
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the speaker cable to the palm-rest and keyboard assembly.
4. Connect the speaker cable to the system board.
5. Connect the touchpad cable to the system board and close the latch to secure the cable.
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Removing and installing components
23
To Next Page
Loading...
