4. Remove the WLAN card.
5. Remove the display assembly.
6. Remove the display bezel.
The following image indicates the location of display hinges and provides a visual representation of the removal procedure.
1. Remove the four (M2.5x2.5) screws that secure the display hinges to the display back-cover.
2. Remove the two (M2x2) screws that secure the display hinges to the display back-cover.
3. the display hinges off the display back-cover.
Installing the display hinges
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of display hinges and provides a visual representation of the installation procedure.
1. Align the screw holes on the hinges with the screw holes on the display back-cover.
2. Replace the two (M2x2) screws that secure the display hinges to the display back-cover.
3. Replace the four (M2.5x2.5) screws to secure the display hinges to the display back-cover.
1. Install the display bezel.
2. Install the display assembly.
3. Install the WLAN card.
4. Install the battery.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
Camera
Removing the camera
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the WLAN card.
5. Remove the display assembly.
6. Remove the display bezel.
7. Remove the display panel.
The following image indicates the location of camera and provides a visual representation of the removal procedure.
1. Using a plastic scribe, pry the camera from the alignment post on the display back-cover.
2. Turn over the camera and disconnect the camera cable off the camera.
3. Peel the tape off the camera and lift the camera off the display back-cover.
Installing the camera
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of camera and provides a visual representation of the installation procedure.
1. Adhere the camera to the display cable (tape) and connect the camera cable to the camera and turn it over.
2. Using the alignment post, turn the camera over and adhere to the display back-cover.
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the WLAN card.
5. Install the battery.
34
Removing and installing components
To Next Page
Loading...
