11. Remove the speaker from the computer.
NOTE: To replace the speaker, see Installing The Speaker.
Installing The Speaker
NOTE: To remove or locate the speaker, see Removing The Speaker.
1. Place the speaker into its slot on the computer.
2. Tighten the screws that secure the speaker to the computer.
3. Route the speaker cable back into its routing guide on the computer.
4. Secure the speaker cable to computer, using the cloth tapes provided.
5. Install the audio board and the hard drive.
6. Install the display closure sensor.
7. Install the battery.
8. Install the base cover.
9. Install the Secure Digital (SD) card.
10. Follow the procedures in After Working Inside Your Computer.
26
To Next Page
Loading...
