Dell Vostro V130 - Removing the Display Closure Sensor

Display Closure Sensor
Removing The Display Closure Sensor
1. Follow the procedures in Before Working On Your Computer
2. Remove the Secure Digital (SD) card.
3. Remove the base cover.
4. Remove the battery.
5. Disconnect and release the flex cable that connects the display closure sensor board to the system board.
6. Remove the screws that secures the display closure sensor to the computer.
7. Lift the display closure sensor up and away from the computer along with its flex cable.
NOTE: To install the display closure sensor, see Installing The Display Closure Sensor.
53