Dell W15B - Removing the Rubber Feet; Prerequisites; Procedure

Removing the rubber feet
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the stand.
2 Follow the procedure from step 1 to step 2 in “Removing the optical
drive”.
3 Remove the back cover.
4 Follow the procedure from step 1 to step 4 in “Removing the hard-drive”.
5 Remove the system-board shield.
6 Remove the fan.
7 Remove the heat sink.
8 Remove the memory module.
9 Remove the speakers.
10 Remove the wireless card.
11 Remove the system board.
12 Follow the procedure from step 1 to step 6 in “Removing the display
assembly”.
Procedure
1 Remove the screws that secure the rubber feet to the display bezel.
78