Dell W15B - Replacing the Rubber Feet; Procedure; Post-Requisites

Replacing the rubber feet
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the rubber feet with the screw holes on the
display bezel.
2 Replace the screws that secure the rubber feet to the display bezel.
Post-requisites
1 Follow the procedure in step 2 to step 6 in “Replacing the display
assembly”.
2 Replace the system board.
3 Replace the wireless card.
4 Replace the speakers.
5 Replace the memory module.
6 Replace the heat sink.
7 Replace the fan.
8 Replace the system-board shield.
9 Follow the procedure in step 3 to step 7 in “Replacing the hard-drive”.
10 Replace the back cover.
11 Follow the procedure in step 4 in “Replacing the optical drive”.
12 Replace the stand.
80