Steps
1. Align the screw hole on each solid state drive thermal bracket with the respective screw hole on the palm rest and keyboard
assembly.
2. Replace the seven screws (M2x4) to secure the battery to the palm rest and keyboard assembly.
3. Connect the battery cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Memory module
Removing the memory module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image indicates the location of the memory modules and provides a visual representation of the removal
procedure.
Removing and installing components
17
To Next Page
Loading...
