Steps
1. Place the antennas into the slots on the palm-rest and keyboard assembly.
2. Route the antenna cable through the routing guides on the palm-rest and keyboard assembly.
NOTE: Route the antenna cable under the keyboard-control cable.
3. Adhere the tapes that secure the antenna cable to the palm-rest and keyboard assembly.
4. Align the screw holes on the right antenna with the screw holes on the palm-rest and keyboard assembly.
5. Replace the four screws (M2x2) that secure the right antenna to the palm-rest and keyboard assembly.
6. Align the screw holes on the left antenna with the screw holes on the palm-rest and keyboard assembly.
7. Replace the four screws (M2x2) that secure the left antenna to the palm-rest and keyboard assembly.
Next steps
1. Install the system board.
2. Install the display assembly.
3. Install the audio-daughter board.
4. Install the left fan.
5. Install the right fan.
6. Install the heat sink.
42
Removing and installing components
To Next Page
Loading...
