Table 7. System setup options—Storage menu (continued)
Storage
This technology is part of the SMART (Self-Monitoring Analysis and Reporting
Technology) specification
Default: OFF
Drive Information Displays the information of various onboard drives.
Enable MediaCard Enables to switch all media cards On/Off or set the media card to read-only
state.
By default, Enable Secure Digital (SD) Card is selected.
Table 8. System setup options—Display menu
Display
Display Brightness
Brightness on battery power Sets the screen brightness when the computer is running on battery power.
Default: 50
Brightness on AC power Sets the screen brightness when the computer is running on AC power.
Default: 0
Touchscreen Enables or disables the touchscreen for the OS.
NOTE: The touchscreen will always work in the BIOS setup irrespective of
this setting.
Full Screen Logo Enabled or disabled the computer to display full screen logo if the image match
screen resolution.
Default: OFF
Direct Graphics Controller Direct
Output Mode
When enabled, the computer will set all external displays to be managed by
the discrete graphics controller, with the purpose of enabling unique discrete
graphics controller features.
Default: OFF
Table 9. System setup options—Connection menu
Connection
Wireless Device Enable Enable or disable internal WLAN/Bluetooth devices.
By default, WLAN is selected.
By default, Bluetooth is selected.
Enable UEFI Network Stack
Enable UEFI Network Stack When enabled, UEFI networking protocols are installed and available, allowing
pre-OS and early OS networking features to use any enabled NICs. This may be
used without PXE turned on.
Default: ON
Wireless Radio Control
Control WLAN radio Enables to sense the connection of the computer to a wired network and
subsequently disable the selected wireless radios (WLAN and/or WWAN).
Upon disconnection from the wired network, the selected wireless radios are
re-enabled.
Default: OFF
Http(s) Boot Feature
System setup 51
To Next Page
Loading...
