DeLonghi EC9555.M - Page 13

13
41 42
A
B
4. Add water up to level B (g. 42). Now reposition the water
tank in the machine.
43 44
5. Make sure that the portalter (C1) is not attached. Position a
container under the coee spout and the hot water spout, and
another under the steam wand (A7) (g. 43).
6. Press the button (B6) and hold until the indicator
(B10) starts to blink.
7. Press the OK button: the corresponding indicator will blink.
8. The descaling programme starts and the descaler liquid comes
out of the spouts. The descale programme removes limescale
deposits from the inside of the machine by automatically per-
forming a series of rinses and pauses until the tank is empty.
Descaling ceases and the OK indicator turns blue. This means
that a rinse cycle must be carried out:
9. Empty the container used to collect the descaler solution
and reposition it under the spouts.
10. Remove the water tank, empty out any residual descaler
solution, rinse under running water and ll with fresh
water up to the MAX level (g. 45). Return the tank to the
machine.
45
MAX
11. Press the OK button. The rinse cycle starts.
12. Once the rinse cycle has been completed, water will stop
draining out and the machine is ready for use.
13. Empty the containers used to collect the rinse water.
14. Pull out and empty the drip tray, then reinsert it.
15. Remove the tank, ll with cold water and return it to the
machine.
16. The OK indicator turns white.
The machine is now ready for use.
Please note:
• The descaling cycle can be started up at any time (even if
the relative indicator is not yet on).
• Should descaling be started up by mistake, it can be
stopped by pressing the button and holding for 10
seconds; the rinse cycle cannot be stopped.
• After 30 seconds without a button being pressed, the ma-
chine exits the descaling programme automatically.
12. CLEANING THE COFFEE SPOUT A19
When the indicator lights up (orange) (B11), it means
that the coee circuit needs to be cleaned. Use De’Longhi clean-
ing tabs (C9) to carry out the cleaning cycle. For more informa-
tion, visit www.delonghi.com.
1. Insert the 1-cup lter (C2) in the holder (C1) (g. 26).
2. Position the cleaning accessory in the lter (C8) (g. 27)
and press home.
3. Place the cleaning tab on the accessory (g. 28).
4. Attach the portalter to the coee spout (A19).
5. Fill the tank(A15) with water. Make sure the drip tray (A11)
is empty.
6. Press the button (B5) and hold until the indica-
tor (B11) starts to blink.
7. Press OK (B4) to start cleaning: the OK indicator blinks to
indicate that cleaning is in progress.
8. When delivery stops and the OK indicator turns blue, it is
time to run a rinse cycle.