15
provides more cuts per inch and a finer, smoother finish. For efficiency, operate the machine at the faster feed rate for
- particularly in hard wood, the slower feed speed is better because of less strain on the motor and a better finish.
operate by gravity and no adjustment is required. However, you should inspect them occasionally to confirm that they
are free of gum and pitch and that they move and operate correctly.
HOW TO CONTROL THE FEED SPEED
Change speeds only while the motor is running. DO NOT change speeds while planing.
USE OF THE ANTI-KICKBACK FINGERS
When inspecting and cleaning the anti-kickback fingers, disconnect the machine from the power
source.
A
Fig. 36
HOW TO ADJUST BELT TENSION
Disconnect the machine from the power source.
Fig. 37
Fig. 38
A
C
D
B
S
Fig. 35
To Next Page
