EasyManuals Logo

Delta 36-040 User Manual

Delta 36-040
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
CONNECTING SAW TO POWER SOURCE
POWER CONNECTIONS
A separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should be
protected with a 20 Amp time lag fuse. Before connecting the motor to the power line, make sure the switch is in the
“OFF” position and be sure that the electric current is of the same characteristics as indicated on the tool. All line con-
nections should make good contact. Running on low voltage will damage the motor.
MOTOR SPECIFICATIONS
Your miter saw is wired for 110-120 volt, 60 HZ alternating current. Before connecting the miter saw to the power
source, make sure the switch is in the “OFF” position. The motor provides a no-load speed of 5200 RPM.
DOUBLE-INSULATED TOOLS
REPLACEMENT PARTS
When servicing, use only identical replacement parts.
POLARIZED PLUGS
To reduce the risk of electric shock, this equipment has a polarized plug one blade is wider than the other). This plug
will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Delta 36-040 and is the answer not in the manual?

Delta 36-040 Specifications

General IconGeneral
BrandDelta
Model36-040
CategorySaw
LanguageEnglish

Related product manuals