Delta 36-655 - Installing Switch

15
Figure 35
Mount switch (A) using hex head screws (2) and square
nuts (2). Install screws with square nuts facing up (B). Do
not tighten screws.
Figure 36
Slide square nuts (B) into bottom channel of front rail.
Figure 37
Move switch (A) along front rail to a convenient position.
Tighten the two screws. Run the switch to motor cord
(shortest) (B) up over cabinet top. Make connection with
motor cord (C).
Fig. 35
Fig. 36
Figure 38
Attach motor cord (A) to inside of cabinet using supplied
cable clamp, hex screw, lock washer, and flat washer (B).
Fig. 38
Fig. 37
Installing Switch
DISCONNECT TOOL FROM POWER
SOURCE.