Delta 36-655 - Tool Holders and Rail End Caps; Dust Port; Fence and Micro-Adjusting Knob

16
Tool Holders and Rail End Caps
Figure 39
Install front and rear end caps (A) on both ends of fence
rails using self tapping screws (4). Install fence holders (B)
using self tapping pan head screws (4). Install wrench
hook (C) using self tapping pan head screws (2). Install
miter gage holder (D) using self tapping pan head screws
(4).
Figure 40
Attach dust port (A) to saw cabinet using pan head screws
(4) and hex nuts (4).
Figure 41
Turn fence body (A) on its side. Attach micro-adjusting
knob (B) to fence using button head screws (2).
Fig. 39
Fig. 40
Figure 42
With the fence locking handle (A) in the raised position,
lower the rip fence (B) onto the fence rail (C). Lock the rip
fence by pushing down handle (A).
Fig. 42
Fig. 41
Dust Port
DISCONNECT TOOL FROM POWER
SOURCE.
Fence and Micro-Adjusting Knob
DISCONNECT TOOL FROM POWER
SOURCE.