Delta 36-655 - Miter Gage; Cross Cut Fence with Depth Stop

17
Figure 43
The miter gage (A) is equipped with a T-slot bar (B).
Engage bar at end of miter slot (C) and slide miter gage
onto saw table.
Figure 44
Install hex socket screws (2) and M5 nuts (2)
thru miter gage body (A). Slide cross cut fence (B) over
screws and onto miter gage assembly using channel (C)
on side of fence. Tighten screws with fence at desired
position.
Note the assembled depth stop (D).
Figure 45
Attach depth stop assembly (A) by sliding onto cross cut
fence (B) using channel (C) on top of fence. Lock depth
stop using lock knob (D).
Fig. 43
Fig. 44
Fig. 45
Miter Gage
DISCONNECT TOOL FROM POWER
SOURCE.
Cross Cut Fence with Depth Stop
DISCONNECT TOOL FROM POWER
SOURCE.