To Next PageTo Next PageWhat to do if my Delta Saw fails to start?
If your Delta Saw fails to start, first ensure the cord plug prongs are making good contact in the receptacle. Also, check the reset button on the “GFI” receptacle, if applicable. Finally, inspect your power line for blown fuses or open circuit breakers.
General| Type | Table Saw |
|---|---|
| Blade Diameter | 10 inches |
| Motor Power | 15 Amp |
| Table Size | 40 inches x 27 inches |
| Weight | 250 lbs |
| Arbor Size | 5/8 inches |
| Voltage | 120 V |
| Max Rip Right | 30 inches |
| No-Load Speed | 5000 RPM |
| Rip Capacity | 30 inches |
| Dust Port Size | 2.5 in |
| Max Depth of Cut at 90 Degrees | 3-1/8 inches |
| Max Depth of Cut at 45 Degrees | 2 1/4 inches |
Lists technical details including cut depth, rip capacity, motor specs, and blade diameter.
Explains safety alert symbols and common technical terms used in the manual.
Details safety precautions specific to table saw operation and components.
Detailed steps for safely installing the saw blade onto the arbor.
Procedures for installing and ensuring the proper function of safety guards.
Details how to align the blade parallel to the miter gauge slot for safe cutting.
How to raise or lower the saw blade for different cut depths.
How to adjust the riving knife height for through and non-through cuts.
Detailed instructions for performing rip cuts safely and effectively.
Guidance on performing rip cuts with the blade tilted at an angle.
Procedures for making cross cuts accurately and safely.
Instructions for making cross cuts with a beveled blade angle.
How to set the miter gauge for angled cross cuts.
Instructions for making cuts that combine bevel and miter angles.
Essential information for making cuts like grooves and rabbets.
Step-by-step guide for performing non-through cuts.
Explanation of push stick usage and construction.
