MAKING ADJUSTMENTS
FIGURE 25
FIGURE 26
SQUARING THE BLADE
VERTICALLY TO THE TABLE
1. Place a combination square
B
against the table and the
side of the blade, avoiding contact with the teeth. See
Figure 27.
2. If it is not square, adjust the 0° stop as shown in
“Adjusting The Bevel Stops”.
FIGURE 27
B
4. Using a 5mm Hex Wrench loosen the rear trunnion bolts
1/2 turn, found below the table top. See Figure 25.
5. If the rear of the blade was too close to combination
square, place a block of wood on the right side of the
blade. Lightly tap with a small hammer or rubber mallet to
achieve the correct parallelism adjustment. See Figure 26.
6. Re-tighten the trunnion bolts with 5mm Hex Wrench.
Re-check alignment after bolts are re-tightened.
21
To Next Page
Loading...
