ASSEMBLY
ATTACHING STAND TO SAW
1. Place Saw Body
PC1
on Stand Assembly, while aligning the
screw holes in the Saw Stand with the threaded holes in
the Saw Base. See Figure 5.
2. Tighten (4) M8 x 55mm Pan Head Hex Socket Screws
HP6
,
with supplied Combination 4mm Allen Wrench
HP9
to
secure Stand Assembly to Saw.
NOTE: DO NOT over tighten. Hex wrench storage provided on
saw near fence storage bracket.
FIGURE 5
PC1
14 15
To Next Page
Loading...
