Delta 36-6013 - Unpacking; Package Contents

UNPACKING
PACKAGE CONTENTS
36-6013 Saw Body
Rip Fence
10 inch Carbide Tipped Blade
Miter Gauge
Blade Guard Assembly
Anti-Kickback Pawls
Throat Plate
Open End Blade Wrench
Closed End Blade Wrench
Push Stick
Stand Part 1
Stand Part 2
Stand Legs (4)
PC1
PC1
PC2
PC2
PC3
PC3
PC4
PC4
PC5
PC5
PC6
PC6
PC7
PC7
PC8
PC8
PC9
PC9
PC10
PC13
PC12
PC11
PC10
PC11 PC12 PC13
Prior to tool assembly and use, read this manual thoroughly to familiarize yourself with proper assembly, maintenance and safety
procedures.
Check shipping carton and machine for damage before unpacking. Carefully remove components in top foam layer. Remove the top layer
of foam then remove all components in the bottom layer of foam. Lay out all parts on a piece of cardboard or other clean, at surface. Two
or more people are needed to lift the saw out of the carton. ALWAYS check for and remove protective shipping materials around motors
and moving parts. DO NOT discard shipping carton and packing materials until you have carefully inspected the contents, assembled the
machine and are satised that it operates correctly.
Compare package contents to “Package Contents” section and “Hardware Bag Contents” section prior to assembly to make sure all
items are present. Carefully inspect parts to make sure no damage occurred during shipping. If any parts are missing, damaged or pre-
assembled, DO NOT assemble. Instead, call DELTA
®
Customer Service at (toll free) 1-800-223-7278.
After assembly remove any protective materials and coatings from all of the parts and the table saw. The protective coatings can be
removed by spraying WD-40
®
on them and wiping them off with a soft cloth. This may need to be redone several times before all of the
protective coatings are removed completely.
10 11