ASSEMBLY
FIGURE 19
FIGURE 20
ON-BOARD STORAGE
Storage is located on the left side and right side of the machine as seen in Figures 19 & 20.
Right Side Storage Figure 20:
Blade Wrenches
Riving Knife (with Blade
Wrenches)
Blade Guard Assembly
Anti-Kickback Pawls
(Behind Blade Guard Assembly)
Left Side Storage Figure 19:
Rip Fence
Push stick
Miter Gauge
PC2
PC4
PC5
PC6
A
B
PC10
PC2
PC5
B
PC10
PC4
LEVELING THE THROAT PLATE
To install throat plate
PC7
, slip tab into slot at back of saw and push
down the front of the throat plate to secure in place. See Figure 21.
NOTE: There are four screws pre-assembled to the throat plate
that are used for leveling the throat plate if necessary.
1. Turn screws clockwise to raise the throat plate, counter
clockwise to lower.
2. Throat Plate should not be above the table or more than
1/36 inch (0.7mm) below the table on infeed side. On
outfeed side plate should be below the table or no more
than 1/36 inch (0.7mm) above the table.
FIGURE 21
Leveling screws Leveling screws
(4)(4)
PC7
PC6
A
MAKING ADJUSTMENTS
19
To Next Page
Loading...
