Delta 36-6013 - Using Color-Coded Scales

MAKING ADJUSTMENTS
FIGURE 32
FIGURE 34
FIGURE 33
USING COLOR-CODED SCALES
The black tab correspond to the black scale with white numbers.
• The black tabs in the middle of the rail can be used for right
rip cut 0 inches to 15 inches.
• To use the black scale with white numbers, insert the fence
notches into the black tab on the rail and use clear indicator.
See Figure 32.
Each corresponding scale should be used to measure the distance
between the inside face of the blade to the inside face of the fence.
Adjust the width of the table saw by using the table extension.
Release the table “lock” by lifting the extension lock handle
upwards.
The white extension tabs correspond to the white scale with black
numbers.
• The white tabs on the right of the rail can be used for right rip
cut 10 inches to 25 inches.
• To use the white scale with black numbers, insert the fence
notches into the white extension tabs on the rail and use red
indicator.
See Figure 33.
The blue tabs correspond to the black scale with blue numbers.
• The blue tabs on the left of the rail can be used for left rip cut
0 inches to 12 inches.
• To use the black scale with blue numbers, insert the fence
notches into the blue tabs on the rail and use clear indicator.
See Figure 34.
BLACK TAB
WHITE TAB
BLUE TAB
CLEARCLEAR
INDICATORINDICATOR
BLACK SCALE W/ BLACK SCALE W/
WHITE NUMBERSWHITE NUMBERS
REDRED
INDICATORINDICATOR
WHITE SCALE WHITE SCALE
W/ BLACK NUMBERSW/ BLACK NUMBERS
CLEARCLEAR
INDICATORINDICATOR
BLACK SCALE BLACK SCALE
W/ BLUE NUMBERSW/ BLUE NUMBERS
24 25