30
The 120/240 volt, dual-voltage motor supplied with
your machine was shipped prepared for 120 volt
operation. It can be converted for 240 volt operation.
For conversion from 120 volt to 240 volt, please call
ahead to DELTA Customer Care at 1-800-223-7278.
Use the following instructions to convert your saw to
240 volts
1. Remove 4 screws (A) Fig 38 and remove rear panel
(B).
2. Remove 2 screws (C) and remove plastic cover (D).
3. Slide switch (E) from 120v to 240v position.
4. Replace cover (D) and 2 screws (C).
5. Replace rear cover B and 4 screws (A).
6. The 120 volt power cord plug must also be replaced
with a UL/CSA listed plug suitable for 240 Volts 15
AMPS.
Either use a qualified electrician to do the conversion or
take the machine to an Authorized Service Center. The
machine must conform to the National Electric Code
and all local codes and ordinances.
Use the 240 volt plug ONLY in an outlet that has the
same configuration as the plug Illustrated on page 8,
Fig. C. use an adapter with the 240 volt plug.
5
A
B
C
D
E
To Next Page
Loading...
