Delta Amplon MX Series - UPS Setting

22
Chapter 3 Operation
3.5 UPS Setting
There are three parameters to set up the UPS.
Parameter 1
Parameter 2
There are two parameters to set up
the UPS.
Parameter 1: It’s for program alterna-
tives. Refer to below table.
Parameter 2 is the setting options or
values for each program.
z
z
01: Output voltage setting
Parameter 2: Output voltage
You could choose the following output voltage:
200: presents output voltage is 200Vac
208: presents output voltage is 208Vac
220: presents output voltage is 220Vac
230: presents output voltage is 230Vac (Default)
240: presents output voltage is 240Vac