What causes CANbus error on Delta ASD-A2-2043?
A CANbus error on Delta Servo Drives is caused by CANbus off or Error Rx/Tx Counter exceeding 128. NMT Maser send “Reset node“ command to its slave or restart the servo drive.
What to do if Delta Servo Drives show abnormal pulse command?
If your Delta Servo Drives are showing an abnormal pulse command, it could be because the pulse command frequency is higher than the rated input frequency. Correctly set the input pulse frequency.
What to do if write parameter error occurs: exceeds the limit of normal range on Delta ASD-A2-2043?
If the parameter setting value exceeds the limit of normal range, correct the PR command and parameter setting value.
How to fix An error occurs when loading CANopen data in Delta ASD-A2-2043 Servo Drives?
To fix an error occurs when loading CANopen data in Delta Servo Drives, when an error occurs when loading data via EEPROM, use DI.ARST, CANopen 0x1011 Restore default parameter.
How to fix regeneration error in Delta Servo Drives?
If your Delta Servo Drives are showing a regeneration error because you choose the wrong regenerative resistor or does not connect to external regenerative resistor, calculate the value of the regenerative resistor again and correctly set the value of P1-52 and P1-53.
How to troubleshoot serial communication error in Delta ASD-A2-2043?
If you're experiencing a serial communication error with your Delta Servo Drives, check the following: * Improper setting of the communication parameter: Correctly set the parameter value. * Incorrect communication address: Correctly set the communication address. * Incorrect communication value: Correctly set the value.
How to resolve CANopen PDO is read-only and write-protected in Delta ASD-A2-2043 Servo Drives?
To resolve CANopen PDO is read-only and write-protected in Delta Servo Drives, when the specified object in the message is write- protected, use NMT: Reset node or 0x6040.Fault Reset.
How to resolve CANopen PDO is not allowed in PDO in Delta Servo Drives?
To resolve CANopen PDO is not allowed in PDO in Delta Servo Drives, when the specified object in the message does not support PDO, use NMT: Reset node or 0x6040.Fault Reset.
What to do if index error occurs when accessing CANopen object on Delta Servo Drives?
If the specified Index in the message does not exist, NMT Maser send “Reset node“ command to its slave or reset the fault by sending the control word (0x6040) through CAN communication (the value of CANopen object 0x6040 should be reset).
What to do if sub-index error occurs when accessing CANopen object on Delta ASD-A2-2043 Servo Drives?
If the specified Sub-index in the message does not exist, NMT Maser send “Reset node“ command to its slave or reset the fault by sending the control word (0x6040) through CAN communication (the value of CANopen object 0x6040 should be reset).
General| Brand | Delta |
|---|---|
| Model | ASD-A2-2043 Series |
| Category | Servo Drives |
| Language | English |
To Next Page
